So what is in my Africa Twin toolkit?

 

I have had lots of requests to make up toolkits for riders and my advice is almost always the same, you only need to worry and carry the tools you both know how to use and will fix the bits on your bike you know how to fix… That said, as promised, apart from spare tubes here is what I carry in my CRF1000L toolkit…

  • 8mm, 10mm, 11mm, 12mm and a 15mm open end and ratchet spanner (all these will do the chain adjusters, and all the remaining odd nuts and bolts on the CRF).
  • Three MotionPro tyre levers (08-0284 12-13mm), (08-0288 27mm), (08-0286 22mm).
  • Two MotionPro Rim Shield II plastic covers.
  • 27mm and 22mm socket and drive (you will not break the rear axle torque with the MotionPro levers so either under torque your axle or carry these).
  • 8mm, 10mm and 12mm long reach socket and small driver.
  • HW5 Hex.
  • 17mm Axle key.
  • Flat and cross head screwdriver.
  • Tube patches, glue and rubber gloves.
  • Cable ties.
  • Spare brake lever (53170-MEJ-016) – the only thing that has stopped me dead on the CRF is a broken front brake lever.
  • All in a Kriega tool roll and wrapped in a Karrimore waterproof kit bag.

Africa Twin Toolkit

Stretching my Legs

Testing and preparation are the two key points to ensure a successful road trip. As it was last week when I found myself alone for the first time on an early morning Eurostar bound for Calais and onward to Berlin. The plan was to test the new DCT Africa Twin in anger – to see what was missing and what would break. I am pleased to report that in the first 1800km since leaving the UK apart from about 80ml of oil being used by my ScottOiler and frequent stops for fuel, all is well with the Honda. Pit stops have become lengthy as almost inevitably a few people come and talk about the bike and the travel plans – there are only a few CRF1000D’s on the road in mainland Europe and so far I have only seen one other bike perched on a dealers trade stand when I stopped at the Spinner Brucke bike meet. Onwards to Berlin and a true autobahn speed test.Stretching My Legs

Six weeks with the Africa Twin

Replacing my old R1150GSA was never going be easy, we have collectively covered in excess of 136,000 miles and both have battle scars of drops and dings from the past 10 years together collected from city tours and long solo trips to Scandinavia, eastern Europe and more social trips to Italy and the south of France. My travels have been recorded and published as poems, stories and photoblogs all with the backdrop of a grey well worn BMW.

Africa Twin on the EpyntIn 2014 when the Africa Twin replacement was first shown by Honda as a concept bike it was an intriguing — a 1000cc, tubeless, chain driven, tall and narrow offering and personally not wanting to swap one heavy boxer for another I decided to look for something different and having borrowed and test ridden a number of other potential replacements, I finally settled on a CRF1000 and perhaps for me the most revolutionary elements was the D or the DCT twin clutch semi-automatic box. But, one word of warning if you want to be inconspicuous at the moment do not ride around on a Red Africa Twin, in fact any Africa Twin at the moment is attracting a lot of interest.

The new model was showcased at the NEC in November 2015 and since then deliveries into the UK have been slow but steady and a few manual bikes have made it onto the road but very few DCTS – so in essence what is the bike like to ride?

In a word “easy”. Honda has managed to design a new engine which is a liquid-cooled 4-stroke 8-valve Parallel Twin with 270° crank and uni-cam with a bore and stroke of 92.0 x 75.1 mm giving a capacity of just under one litre at 998cc. Power is modest at just under a claimed 94bhp @ 7500 rpm and almost 100Nm of torque which in day to day riding makes the bike really easy to ride as the pickup very swift and easy to use.

The bike feels tall, I think no doubt helped by the narrowness and if like me, you move from a boxer twin you will immediately noticed the change — filtering in traffic is easy and the DCT makes that whole experience easier as you balance the throttle and rear brake to maintain forward movement at very low speeds.

The most significant change is now doubt the DCT. My last automatic was a ‘step through’ 90 so this was always going to be an improvement. The gearbox has a fully manual mode or the option of automatic with flappy paddle asset or fully automatic (D Mode) all with selectable multiple stage traction control and power modes and a G Mode button… Day to Day D mode is default, switching the power modes does not increase the BHP but rather allows the gearbox to hold onto gears for longer and higher in the rev range — the bike is certainly quick off the lights. Off road the G mode activates a number of additional accelerometers and inclinometers which hold the selected gear for longer and the bike does not change gear unexpectedly on descents or traversing muddy and gavelled tracks — for me as an average off road rider it certainly inspires confidence and I have tackled tracks and lanes I would not have considered on my GSA in a wet and wild Welsh winter.Africa Twin on the Epynt

The front brakes are powerful non servo assisted (which is a positive benefit from my old BMW) 310 mm dual wave floating hydraulic discs with aluminium hubs and radial fit 4-piston callipers fitted with sintered metal pads and the rear is a smaller 256 mm wave hydraulic disc with 2-piston calliper and sintered metal pads. The ABS is switchable dual channel and very intuitive and the rear can be turned off which is essential when you are off tarmac and you actually want to lock up the rear wheel. The DCT is also fitted with a parking break on the LHS which is far enough away so you cannot ever mistake it for a clutch lever. Hill starts just require a slight change in technique in balancing rear break and throttle… the same as slow speed filtering.

Perhaps most controversially Honda have fitter a combination of tubed tyres with a 21” front (90/90) and a 150/70 18” rear — the bike comes fitted with Dunlop TrailSmart which are adequate, but not confidence inspiring and prone to twitching in the wet, on overbanding and metal access covers in the roadway. Within another 1500 miles they will be due for replacement having got 4000 from the OEM rear.

Accessories for the bike are slowly filtering through with Rugged Roads and Touratech offering a number of enhancements and replacement smaller panniers and a modest top box are being fitted to support longer solo trips – I have shelved my very old Zegas on the basis they add too much width to the bike and defeat the narrowness advantage and a PDM60 and Scottoiler have been fitted to help distribute power to my Zumo 590 and avoid the need for tins of spray lube to be carried.

Six weeks have flown past, she has been dropped in the mud, I have broken one brake lever, lost or broken some of the plastic and captive bolt trim fixings… indeed disassembling and replacing the plastic trim takes care and a methodical approach. I am looking forward to putting some more miles on the bike with ferry crossings already booked. Is the new Africa Twin a GS replacement? Yes, for me it is, I do not yet have the same feelings for it as I do my old GSA but that trust has to be earned. The reliability of the technology has yet to be proven but Honda’s reputation for excellent build quality and support help allude any niggles and three years EU breakdown cover comes with the bike — my old GSA now sits in my garage, covered and cosseted – I had forgotten and have certainly forgiven the times she left me stranded with servo or fuel pump failures, its time for me to change and embrace a brave new world of DCT G Mode on a lighter more nimble bike – roll on the next 100,000 miles.

The clutch lever is dead, long live the clutch lever

So I finally took the plunge… last weekend I picked up my Honda CRF1000D, a victory red Africa Twin. Initial impressions of the bike are very good and the DCT gearbox is exceptionally smooth, it is certianly intuitive and perhaps even better than I thought it might be. So far I have only been off road in the Epynt Ranges but the gravel and forest tracks locally proved how good the G Mode DCT box can be – and with the traction control light flashing away, warning and then controlling the rear wheel slip, I scrubbed in the standard Dunlop Trailmax road tyres. I took some stick from bikers old and new telling me it was not a real bike, but I’ve been riding since the age of 16 and I am now aged 52, so even with my poor maths that’s 36 years on two wheels… I don’t have anything else to prove. I am still keeping a manual bike but quite honestly if the technology is this is good then one might wonder if the clutch lever is going to become redundant – I suspect not, or at least not quite yet.Africa Twin

New Workhorse Required

My 15 year old R1150GSA has now taken me on trips covering at least 210,000 km and each year I struggle a little more with insurance, breakdown cover and parts availability. Last year BMW deleted thousands of spares from their catalogue making it more and more difficult for old bike owners to keep their beloved bikes on the road as daily rides. I am not a cynical man but clearly this move was made by BMW Accountants who want riders to buy new bikes every few years rather than keeping models on the road. Even Motorworks and James Sherlock are struggling with some obscure new parts and I keep a good selection of secondhand parts from breakers in stock but it is getting harder…

Now before anyone shouts there is no way I am getting rid of my GSA but I need to be realistic about what I can do on my extended solo trips and have to be self sufficient. For those of you looking at my Overland Motorcycle Workshop resource you will have seen the increasing electrical troubles no doubt caused by older and increasingly brittle wiring and whilst a complete rewire may be the answer perhaps I need to just accept a new bike is required and retire the GSA – she owes me nothing. So the question is what option should I take. I have a refundable deposit on a new Honda Africa Twin but also have my eye on the older technology packaged in the Yamaha SuperTen. Next week sees the launch of the Africa Twin in the UK but I am open to suggestions… anyone…

Africa Twin